Automotive Accessories

Zeph Gage Builds Budget Rear-Only Portal Axle for Jeep XJ

Nerea ValdesNovember 17, 20265 min read1 views

At a glance

  • A custom Ford 9-inch and Humvee-parts assembly costs about one-fifth of a typical portal-axle set and adds clearance at the rear only.
  • Zeph Gage has built a rear-only portal axle for his Jeep XJ using a flipped Ford 9-inch differential, Humvee geared hubs and custom adapters. The setup adds six inches of clearance while avoiding front-end packaging and shock-travel compromises, at about one-fifth the cost of a typical portal-axle set.
Concept illustration of a generic off-road SUV on a workshop lift, with its rear axle, flipped differential, geared hubs and custom brake hardware visible from below.

Portal axles can give an off-roader much more ground clearance, but a typical set costs around $20,000. Zeph Gage has built a rear-only alternative for his Jeep XJ that costs about one-fifth of that, using a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters.

How the flipped differential works

Portal axles place a stack of gears behind each driven wheel instead of hanging shafts and other hardware below the transmission and transfer case. That lets the axle shafts sit higher and leaves less hardware below the frame, especially when tall tires are fitted. The tradeoff is complexity and cost, which is why Gage's low-buck approach is notable.

Two-gear portals like the Humvee units reverse the rotation of the input shaft. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential, turning low-pinion parts into what amounts to a budget high-pinion unit.

Besides adding six inches of clearance, the arrangement retains full shock travel, which is tricky with portal axles, and reduces stress on the differential itself. The result is expected to be effectively bulletproof.

Why only the rear axle

Installing a portal axle only at the rear is a common trick in the remote-control rock crawler scene. By keeping the solid axle up front, Gage avoids the packaging constraints that usually arise when adding portal axles to a vehicle that never had them from the factory. He also avoids restricting shock travel because of those constraints, and the ride height is not raised ridiculously high. The result is a best-of-both-worlds arrangement.

The practical effect is that the rear end can clear obstacles that the front end can simply steer around. Gage's XJ can drive over a five-gallon bucket and still have several inches of spare clearance.

Custom fabrication, not a kit

This is not an off-the-shelf conversion. Gage did substantial custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric emergency brake solenoid, along with packaging and clearance advantages.

More detail on the build, including how Gage matched the gearing front and rear, is available in a video from Outdoor Auto. The core idea, however, is simple: by flipping the differential and combining lower-cost components, Gage created a rear portal axle without paying the usual portal-axle price.

Reported by Nerea Valdes, Exterior Accessories and Weathering Editor.